Toa C-RM700 - Manual (Page 56)

* Applies to the system where the unit and Combination camera are connected in a matched pair. Represents
the total of connected cable distances if multiple Combination cameras or Interface units are connected in
the system (when the CPEV-S cable thicker than 0.65 mm (0.03") in diameter is used).
Note: The design and specifications are subject to change without notice for improvement.
• Accessory
D-sub connector (25 pins, male) ............. 1
Power Source 12 V DC
Current Consumption 130 mA
Slave Remote Controller RS-485, Screwless connector (connectable one slave-designated C-RM700)
Camera Control RS-485 (Type A and Type B), screwless connector
Switcher Control RS-485, screwless connector
Alarm Input RS-232C, D-sub connector (9 pins, male)
Alarm Output/Control Input Alarm output:
16 channels, NPN open collector output, withstand voltage: 20 V DC,
control current: 20 mA, D-sub connector (25 pins, female)
Time adjustment input:
1 channel, no-voltage make contact input, open voltage: 5 V DC,
short-circuit current: 5 mA max.
Home position selection input:
1 channel, no-voltage make contact input, open voltage: 5 V DC,
short-circuit current: 5 mA max.
Display LED indication of alarm status, alarm hold status, auxiliary setting 1, auxiliary
setting 2, automatic operation status, control status, still picture status, lens
speed, and auto focus LCD indication of key entry confirmation
Alarm Signal Continuous alarm tone (can be turned on and off)
Number of Unit Connections Up to 16 (controllable cameras with RS-485 communication)
Maximum Cable Distance 1.2 km (1.31 yd)*
Operating Temperature 0°C to +40°C (32°F to 104°F)
Operating Humidity 80%RH or less (no condensation)
Finish Panel: Surface-treated steel plate, silver, paint
Sides: Rubber
Dimensions 323.6 (W) x 112.7 (H) x 181 (D) mm (12.74" x 4.44" x 7.13")
Weight 1.7 kg (3.75 lb)
133-22-232-2B
URL: http://www.toa.jp/
10. SPECIFICATIONS