Toa C-RM700 - Manual (Page 31)

31
7.4.4. Camera check
Checks Combination Cameras connected to the Camera Control terminal for 30 seconds.
Notes
• Be sure to perform this camera check except when the "TYPE B ONE WAY" has been selected in Protocol
setting.
• Once the Camera Check has been completed, only the cameras recognized when the check was performed
can be controlled. Therefore, be sure to perform the camera check again whenever unrecognized cameras
are found or new cameras are added. Also, in case that unrecognized cameras are still found after
performing camera checks several times, check to be sure that there is no fault with protocol of the camera
side, communication speed settings, wirings, and protocol and I/O speed settings of this unit.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "CAMERA CHECK," and press the SET key.
3. Tilt the joystick left or right to select one of the following setting contents and confirm it with the SET key.
[When "1. Start" is pressed]
The check takes approximately 30 seconds. All keys are disabled during the check.
The check interval is counted down from "30" (seconds) displayed to the right of Line 1.
The camera numbers of the connected Combination cameras are displayed in numerical order on Line 2.
[When "2. Clear" is pressed]
Setting returns to the factory preset.
4. Press the Clear key to return to the menu screen.
The indication "OK" is displayed after the 30-second check is completed.
After check completion, connected cameras can be confirmed by tilting the joystick to the left or right to scroll
the screen.
C A M E R A C H E C K O K
1 , 2 , 3 , 4 , 5 , 1 1 , 1 2
C A M E R A C H E C K O K
1 3 , 1 4
C A M E R A C H E C K O K
1 , 2 , 3 , 4 , 5 , 1 1 , 1 2
C A M E R A C H E C K 2 0
1 , 2 , 3 , 4 , 5 , 1 1 , 1 2
(Example)