Toa C-RM700 - Manual (Page 46)

46
7.4.24. Camera menu
Calls up the camera's menu screen, and performs various Combination camera settings, such as the storage
of preset camera positions.
For detailed operations and settings of the camera menu, refer to the instruction manual included with the
camera.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "CAMERA MENU," and confirm the selection with the SET key.
The unit will wait for entry of the camera number that starts up the menu.
3. Enter the camera number with the numeric keypad, and confirm the entered number with the SET key.
The selected camera menu appears on the monitor. Pressing the Menu key again while the menu is being
displayed on the monitor will turn off the display, returning the display to the camera number entry screen.
4. Repeat Steps 2 and 3 to continue to set other camera numbers.
Press the Clear key to return to the setting item display.
7.4.25. I/O selection
For the unit set to "2. Slave" in the operation mode, perform this selection to remotely control the master
remote controller by connecting the remote controller's RS-232C terminal to a PC.
Note: This screen is displayed only when the unit is designated as a slave.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "I/O SELECTION," and confirm it with the SET key.
3. Tilt the joystick to left or right to select either of the following settings, and confirm it with the SET key.
[Setting contents]
C A M E R A M E N U C H
I / O S E L E C T I O N
1 . S W I T C H E R 1
1. SWITCHER Select this in normal use.
2. ALARM Select this when it is necessary to remotely control the master remote controller by
connecting to a PC.