Toa C-RM700 - Manual (Page 40)

40
7.4.17. Alarm signal
Sets continuous alarm operations.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "ALARM SIGNAL," and confirm the selection with the SET key.
The setting will appear on Line 2.
3. Tilt the joystick to the left or right to select either of the following settings, and confirm it with the SET key.
[Setting contents]
A L A R M S I G N A L
1 . E D G E 1
1. EDGE Terminates alarm operations when the time interval set in the "Alarm time"
setting (next page) passes or when an alarm reset signal is received.
2. LEVEL Terminates alarm operations when the alarm input terminal receives alarm end
data. Also, if "1. ON" has been selected in the "Camera alarm" setting, alarm
operation will stop when all alarm signals from the camera change from close
to open data.
7.4.18. Alarm time
Sets the interval between alarm input and alarm reset.
Note
The Alarm Time can only be set when "1. EDGE" has been selected in the "Alarm signal" setting. This setting
item is not displayed on the menu screen when "2. LEVEL" has been selected.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "ALARM TIME," and confirm the selection with the SET key.
The setting will appear on Line 2.
3. Tilt the joystick to the left or right to select one of the following settings, and confirm it with the SET key.
[Setting contents]
A L A R M T I M E
3 . 2 0 S E C 3
1. 10SEC (10 seconds)
2. 15SEC (15 seconds)
3. 20SEC (20 seconds)
4. 30SEC (30 seconds)
5. 1MIN (1 minute)
6. 2MIN (2 minutes)
7. 3MIN (3 minutes)
8. 4MIN (4 minutes)
9. 5MIN (5 minutes)
10. NO LIMIT (no time limit)
Note: This selection is set to "3. 20SEC" by the factory.
Notes
• If "10. NO LIMIT" is selected, the alarm can only be reset when the Alarm reset key on this unit's top panel is
pressed.
• If Alarm time has been set on the camera, match this unit's alarm time setting and that of the camera.
Note: This selection is set to "1. EDGE" by the factory.