Toa C-RM700 - Manual (Page 36)

36
Multi-Switcher 1. FULL (full screen)
2. SEQUENCE (sequence)
3. 4-SEG SEQ
(sequential 4-segment split-screen display)
4. 4-SEG (4-segment split-screen display)
5. 9-SEG (9-segment split-screen display)
6. 10-SEG (10-segment split-screen display)
7. 16-SEG (16-segment split-screen display)
Note
Make sure that the selected setting is the same as that for the connected
switcher.
7.4.11. Buzzer
Sets whether or not to sound the buzzer when an alarm signal is received.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "BUZZER," then confirm the selection with the SET key.
The setting will appear on Line 2.
3. Tilt the joystick left or right to select either of the following settings, and confirm it with the SET key.
[Setting contents]
B U Z Z E R
1 . O N 1
1. ON Sounds a buzzer when alarm is activated.
2. OFF Sounds no buzzer when alarm is activated.
7.4.12. Initial screen
Sets the screen to be displayed immediately after the power is turned on.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "INITIAL SCREEN," then confirm the selection with the SET key.
The setting will appear on Line 2.
3. Tilt the joystick left or right to select one of the following settings, and confirm it with the SET key.
Note: The setting contents differ depending on the type of switcher connected to the system.
[Setting contents]
I N I T I A L S C R E E N
1 . F U L L 1
Switcher Type Setting contents
Note: This selection is set to "1. ON" by the factory.
Note: This selection is set to "1. FULL " by the factory.