Toa C-RM700 - Manual (Page 28)

28
7.3.2. When the password has been set
Note, however, that the password setting differs from those explained here. Refer to p. 47 .
1. Press the Menu key for 3 seconds or more.
The password entry screen is displayed.
2. Enter the password (4 digits) using the numeric keypad.
3. Press the SET key.
If the entered password is correct, the menu screen is
displayed.
[Some operation examples]
4. Tilt the joystick up or down to select the setting item.
5. Press the SET key to confirm the setting item.
The current setting contents (if not set, the factory-
predetermined setting contents) are displayed at the
lower part of the LCD screen.
In this event, one character "1" of the setting contents
flashes. (The flashing character differs depending on
the content.)
6. Tilt the joystick left or right to select the desired setting
content.
Note
Pressing the Clear key before Step 6 is completed will
return the display to the screen last shown (in Step 4)
before the SET key was pressed without storing the
setting contents.
7. Press the SET key to confirm the setting contents.
The display returns to the screen (in Step 4) to select
the setting item.
8. Repeat Steps 4-7 to continue to set other items.
Press the Menu key again when returning to the normal
screen after setting completion.
1 2 3 4
(Example)
P A S S W O R D
1 2 3 4
MENU
P A S S W O R D
LCD screen
Press for 3 seconds
or more.
SET
O P E R A T I O N M O D E
A U T O R E T U R N
(Example)
SET
A U T O R E T U R N
1 . O N 1
A U T O R E T U R N
1 . O N 1 0 S E C 1
SET
A U T O R E T U R N