Toa C-RM700 - Manual (Page 6)

6
2. GENERAL DESCRIPTION
The TOA C-RM700 Remote Controller is used to remotely control TOA Combination cameras over
communication lines (RS-485). It can remotely control up to 16 camera image switching and cameras in
combination with TOA Multi-Switcher. Also, it is equipped with a 3-axis joystick that permits main operation to
be performed with one hand.
3. FUNCTIONS
• Display Selection Function
The following screen formats can be selected for display of camera images connected to the Multi-Switcher:
full screen, 4-segment, sequential 4-segment, 9-segment, 10-segment or 16-segment split-screen and
sequential full-screen.
• Manual Operation Function
Controls the Combination camera's zoom, focus, pan and tilt functions.
• Preset Position Playback function
Controls the Combination camera's orientation, and displays the camera image on the monitor in the
selected orientation.
• Function Key Programming
Camera numbers or camera number/position combination numbers can be programmed into the function
keys (F1 - F8).
Pressing the function key (F1 - F8) displays the camera image on the full screen. If position numbers have
been set, images of the selected camera orientation can be displayed.
• Abbreviated Number Function (Quick Display Function)
Permits camera numbers or camera number/position combination numbers to be programmed for numbers
1 - 520 depending on settings.
Entering the programmed number with the numeric key pad followed by the SET key displays the camera
images through the camera corresponding the camera number on the full screen, and the image of selected
camera orientation if the position number has been set.
• Alarm Function
Controls the display screen in synchronization with alarm signals input to the surveillance camera system to
which the unit is connected.
When an alarm signal is detected, the image of the corresponding camera takes display precedence. The C-
RM700 also features an Alarm Hold function that temporarily disables channel (camera number) switching in
response to an alarm signal.
This Alarm Hold function prevents the currently displayed screen from being forcibly switched to an alarm-
called screen by an alarm input during alarm hold. (when the Multi-Switcher is connected)
• Camera Protocol
It is equipped with TOA Type A,and TOA Type B which can control TOA Combination Cameras.