Cisco 15327 - Manual (Page 133)

8-5
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 8 Configuring VLANs
Monitoring and Verifying VLAN Operation
pos flag c2 1
!
interface POS0.1
encapsulation dot1Q 1 native
bridge-group 1
!
interface POS0.2
encapsulation dot1Q 2
bridge-group 2
!
interface POS0.3
encapsulation dot1Q 3
bridge-group 3
!
interface POS0.4
encapsulation dot1Q 4
bridge-group 4
Monitoring and Verifying VLAN Operation
After the VLANs are configured on the ML-Series card, you can monitor their operation by entering the
privileged EXEC command show vlans vlan-id. This command displays information on all configured
VLANs or on a specific VLAN (by VLAN ID number).
An example of the show vlans privileged EXEC command commands are shown here:
Example 8-2 show vlans Commands
ML1000-121#show vlans
Virtual LAN ID: 1 (IEEE 802.1Q Encapsulation)
vLAN Trunk Interfaces: POS1
GigabitEthernet0
This is configured as native Vlan for the following interface(s) :
POS1
GigabitEthernet0
Protocols Configured: Address: Received: Transmitted:
Virtual LAN ID: 5 (IEEE 802.1Q Encapsulation)
vLAN Trunk Interfaces: POS1.1
GigabitEthernet0.1
Protocols Configured: Address: Received: Transmitted:
Bridging Bridge Group 2 157 0
Bridging Bridge Group 2 157 0