Cisco 15327 - Manual (Page 23)

T A B L E S
xxiii
Ethernet Card Software Feature and Configuration Guide, R7.2
Table 2-1 ML-Series POS and Ethernet Statistics Fields and Buttons 2-2
Table 2-2 CTC Display of Ethernet Port Provisioning Status 2-2
Table 2-3 CTC Display of POS Port Provisioning Status 2-3
Table 3-1 RJ-11 to RJ-45 Pin Mapping 3-5
Table 3-2 Microcode Image Feature Comparison 3-12
Table 3-3 Cisco IOS Command Modes 3-14
Table 5-1 SONET STS Circuit Capacity in Line Rate Mbps 5-2
Table 5-2 VCAT Circuit Sizes Supported by ML100T-12, ML100X-8, and ML1000-2 Cards 5-3
Table 5-3 Supported Encapsulation, Framing, and CRC Sizes for ML-Series Cards on the ONS 15454 and ONS 15454
SDH
5-4
Table 5-4 Default MTU Size 5-6
Table 5-5 C2 Byte and Scrambling Default Values 5-8
Table 5-6 ML-Series Parameter Configuration for Connection to a Cisco 12000 GSR-Series Router 5-13
Table 7-1 Switch Priority Value and Extended System ID 7-4
Table 7-2 Spanning-Tree Timers 7-4
Table 7-3 Port State Comparison 7-10
Table 7-4 RSTP BPDU Flags 7-13
Table 7-5 Default STP and RSTP Configuration 7-16
Table 7-6 Commands for Displaying Spanning-Tree Status 7-20
Table 9-1 VLAN-Transparent Service Versus VLAN-Specific Services 9-6
Table 9-2 Default Layer 2 Protocol Tunneling Configuration 9-11
Table 9-3 Commands for Monitoring and Maintaining Tunneling 9-13
Table 11-1 Default RIP Configuration 11-5
Table 11-2 Default OSPF Configuration 11-10
Table 11-3 Show IP OSPF Statistics Commands 11-19
Table 11-4 Default EIGRP Configuration 11-21
Table 11-5 IP EIGRP Clear and Show Commands 11-26
Table 11-6 BGP Show Commands 11-28
Table 11-7 IS-IS Show Commands 11-30
Table 11-8 Routing Protocol Default Administrative Distances 11-32
Table 11-9 Commands to Clear IP Routes or Display Route Status 11-33
Table 11-10 IP Multicast Routing Show Commands 11-35