Cisco 15327 - Manual (Page 277)

17-25
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 17 Configuring Cisco Proprietary Resilient Packet Ring
Delete an ML-Series Card from a Cisco Proprietary RPR
Figure 17-11 Three Node Cisco Proprietary RPR Before the Deletion
Figure 17-12 Two Node Cisco Proprietary RPR After the Deletion
To delete an ML-Series card from the Cisco proprietary RPR, you need to complete several general
actions:
SPR 1
POS 1 POS 0
POS 0
POS 0
POS 1
POS 1
= STS circuit created on CTC
Adjacent Node 2
Adjacent Node 1
Delete Node
145251
SPR 1
POS 1
POS 0
POS 0
POS 1
= STS circuit created on CTC
Adjacent Node 2
Adjacent Node 1
This STS circuit
was created after the deletion.
Deleted Node
145253