Cisco 15327 - Manual (Page 544)

A-70
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
show rpr-ieee protection
show rpr-ieee protection
Use this command to display the protection state of the local station, along with brief overview of the
station’s neighbors, timer configuration, and self-detected failures that might contribute to the current
state.
Syntax Description This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged executive
Usage Guidelines Use this command to show the current protection status on the ring.
In this command, protection can be shortened to prot.
Examples router# show rpr-ieee protection
Protection Information for Interface RPR-IEEE0
MAC Addresses
West Span (Ringlet 0 RX) neighbor 000b.fcff.9d34
East Span (Ringlet 1 RX) neighbor 0013.1991.1fc0
Station MAC address 0005.9a3c.59c0
TP frame sending timers:
fast timer: 10 msec
slow timer: 1x100 msec (100 msec)
Protection holdoff timers:
L1 Holdoff Keepalive Detection
West Span 0x10 msec ( 0 msec) West Span 5 msec
East Span 0x10 msec ( 0 msec) East Span 5 msec
Configured protection mode: STEERING
Protection Status
Ring is IDLE
Protection WTR period is 10 sec. (timer is inactive)
Self Detected Requests Remote Requests
West Span IDLE West Span IDLE
East Span IDLE East Span IDLE
Distant Requests
East Span IDLE West Span IDLE
West Span Failures: none
East Span Failures: none
Related Commands None