Verifying the is-is configuration, Table 11-7 – Cisco 15327 User Manual

Page 188

Advertising
background image

11-30

Ethernet Card Software Feature and Configuration Guide, R7.2

Chapter 11 Configuring Networking Protocols

Verifying the IS-IS Configuration

Example 11-16

shows an example of IS-IS routing configuration.

Example 11-16 Configuring IS-IS Routing

Router(config)# router isis

Router(config-router)# net 49.0001.0000.0000.000a.00

Router(config-router)# interface gigabitethernet 0

Router(config-if)# ip router isis

Router(config-if)# end

For more information about configuring IS-IS routing, refer to the “Configuring Integrated IS-IS”
chapter in the Cisco IOS IP and IP Routing Configuration Guide.

Verifying the IS-IS Configuration

To verify the IS-IS configuration, use the EXEC commands listed in

Table 11-7

.

Example 11-17

shows

examples of the commands in

Table 11-7

and their output.

Note

The ML Series does not support Connectionless Network Service Protocol (CLNS) routing.

Example 11-17 IS-IS Configuration

Router# show ip protocols

Routing Protocol is "isis"

Invalid after 0 seconds, hold down 0, flushed after 0

Outgoing update filter list for all interfaces is not set

Incoming update filter list for all interfaces is not set

Redistributing: isis

Command

Purpose

Step 1

Router(config)# router isis [

tag]

Defines IS-IS as the IP routing protocol.

Step 2

Router(config-router)# net

network-entity-title

Configures network entity titles (NETs) for the
routing process; you can specify a name for a
NET as well as an address.

Step 3

Router(config-router)# interface

interface-type interface-id

Enters interface configuration mode.

Step 4

Router(config-if)# ip address

ip-address

mask

Assigns an IP address to the interface.

Step 5

Router(config-if)# ip router isis [

tag]

Specifies that this interface should run IS-IS.

Step 6

Router(config-if)# end

Returns to privileged EXEC mode.

Table 11-7

IS-IS Show Commands

Command

Purpose

Router# show ip protocols [summary]

Displays the protocol configuration.

Router# show isis database

Displays the IS-IS link-state database.

Router# show clns neighbor

Displays the ES and IS neighbors.

Advertising