Ce-100t-8 sonet/sdh circuits and features, Available circuit sizes and combinations, Table 24-3 – Cisco 15327 User Manual

Page 415: Table 24-4, Table 24-5

Advertising
background image

24-7

Ethernet Card Software Feature and Configuration Guide, R7.2

Chapter 24 CE-100T-8 Ethernet Operation

CE-100T-8 SONET/SDH Circuits and Features

CE-100T-8 SONET/SDH Circuits and Features

The CE-100T-8 has eight POS ports, numbered one through eight, which can be managed with CTC or
TL1. Each POS port is statically mapped to a matching Ethernet port. By clicking the card-level
Provisioning > POS Ports tab, the user can configure the Administrative State, Framing Type, and
Encapsulation Type. By clicking the card-level Performance > POS Ports tab, the user can view the
statistics, utilization, and history for the POS ports.

Available Circuit Sizes and Combinations

Each POS port terminates an independent contiguous concatenation (CCAT) or virtual concatenation
(VCAT) circuit. The SONET/SDH circuit is created for these ports through CTC or TL1 in the same
manner as a SONET/SDH circuit for a non-Ethernet line card.

Table 24-3

and

Table 24-4

show the

circuit sizes available for the CE-100T-8.

A single circuit provides a maximum of 100 Mbps of throughput, even when a larger STS-3c or VC-4
circuit, which has a bandwidth equivalent of 155 Mbps, is provisioned. This is due to the hardware
restriction of the Fast Ethernet port. A VCAT circuit is also restricted in this manner.

Table 24-5

shows

the minimum SONET circuit sizes required for wire speed service delivery.

Table 24-6

shows the minimum SDH circuit sizes required for 10 Mbps and 100 Mbps wire speed

service.

Table 24-3

Supported SONET Circuit Sizes of CE-100T-8 on ONS 15454

CCAT

VCAT High Order

VCAT Low Order

STS-1

STS-1-1v

VT1.5-nV (n= 1 to 64)

STS-3c STS-1-2v

STS-1-3v

Table 24-4

CE-100T-8 Supported SDH Circuit Sizes of CE-100T-8 on ONS 15454 SDH

CCAT

VC-3 VCAT

VC-12 VCAT

VC-3

VC-3-1v

VC-12-nV (n= 1 to 63)

VC-4

VC-3-2v

VC-3-3v

Table 24-5

Minimum SONET Circuit Sizes for Ethernet Speeds

Ethernet Wire Speed

CCAT High Order

VCAT High Order

VCAT Low Order

Line Rate 100BASE-T

STS-3c

STS-1-3v, STS-1-2v

1

1.

STS-1-2v provides a total transport capacity of 98 Mbps.

VT1.5-xv (x=56-64)

Sub Rate 100BASE-T

STS-1

STS-1-1v

VT1.5-xv (x=1-55)

Line Rate 10BASE-T

STS-1

Not applicable

VT1.5-7v

Sub Rate 10BASE-T

Not applicable

Not applicable

VT1.5-xv (x=1-6)

Advertising