Eigrp interface mode commands – Cisco 15327 User Manual
Page 181
11-23
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 11 Configuring Networking Protocols
Configuring EIGRP
Use the no forms of these commands to disable the feature or return the setting to the default value.
shows the output for the show ip protocols privileged EXEC command.
Example 11-8
show ip protocols privileged EXEC Command Output (for EIGRP)
Router# show ip protocols
Routing Protocol is "eigrp 1"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 1
Automatic network summarization is in effect
Automatic address summarization:
192.168.3.0/24 for POS0
192.168.2.0/24 for FastEthernet0
Maximum path: 4
Routing for Networks:
192.168.2.0
192.168.3.0
Routing Information Sources:
Gateway Distance Last Update
192.168.2.1 90 00:03:16
Distance: internal 90 external 170
EIGRP Interface Mode Commands
Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps:
Step 6
Router(config)# offset list
[{
access-list-number | name}
] {
in
|
out
}
offset
[
type-number
]
(Optional) Applies an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through
EIGRP. You can limit the offset list with an access list or an
interface.
Step 7
Router(config)# no auto-summary
(Optional) Disables automatic summarization of subnet
routes into network-level routes.
Step 8
Router(config)# ip summary-address
eigrp
autonomous-system-number
address-mask
(Optional) Configures a summary aggregate.
Step 9
Router(config)# end
Returns to privileged EXEC mode.
Step 10
Router# show ip protocols
Verifies your entries.
Step 11
Router# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.
Command
Purpose