No] rpr-ieee tx-traffic strict – Cisco 15327 User Manual
Page 505
A-31
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] rpr-ieee tx-traffic strict
[no] rpr-ieee tx-traffic strict
Use this command to configure either all or none of the traffic added by the node to have the strict order
(SO) bit set on or off in the IEEE 802.17b-based RPR header.
Syntax Description
This command has no arguments or keywords.
Defaults
The default is off.
Command Modes
IEEE 802.17b based RPR interface configuration
Usage Guidelines
By default, the SO bit is turned off. You can turn it on in the IEEE 802.17b based RPR interface with
this command if you need to accommodate an application with high sensitivity to out-of-order packets,
originating at this node. This command is seldom utilized.
Examples
In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee tx-traffic strict
Related Commands
None