Cisco 15327 - Manual (Page 311)

18-19
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 18 Configuring Ethernet over MPLS
RPRW Alarm
Table 18-2 shows the privileged EXEC commands supported to monitor and verify the state of IP RSVP
on the ML-Series cards.
RPRW Alarm
For information on the ONS 15454 RPRW alarm, refer to the online version of the Cisco ONS 15454
Troubleshooting Guide, Release 5.0 at
http://www.cisco.com/univercd/cc/td/doc/product/ong/15400/r50docs/r50tblsh/r50alts.htm
show mpls traffic-eng link-management
igp-neighbors
Displays IGP neighbors.
show mpls traffic-eng link-management
interfaces
Displays interface resource and
configuration information.
show mpls traffic-eng link-management summary Displays a summary of link
management information including
link counts.
show mpls traffic-eng topology Displays the MPLS-TE global
topology as currently known at this
node.
show mpls traffic-eng tunnel Displays information about
MPLS-TE tunnels, including LSP
Tunnels Process and RSVP process.
show mpls traffic-eng tunnel summary Displays condensed information
about MPLS-TE tunnels.
Table 18-3 Commands for Monitoring and Verifying MPLS-TE (continued)
Command Purpose
Table 18-4 Commands for Monitoring and Verifying IP RSVP
Command Purpose
show ip rsvp interface
[ interface-type interface-number]
Displays Resource Reservation Protocol (RSVP)-related
information.
show ip rsvp installed
[ interface-type interface-number]
Displays RSVP-related installed filters and corresponding
bandwidth information.
show ip rsvp neighbor
[ interface-type interface-number]
Displays current RSVP neighbors.
show ip rsvp sender [ interface-type
interface-number]
Displays RSVP path-related sender information currently
in the database.
show ip rsvp request
[ interface-type interface-number]
Displays RSVP-related request information being
requested upstream
show ip rsvp reservation
[ interface-type interface-number]
Displays RSVP-related receiver information currently in
the database