Cisco 15327 - Manual (Page 56)

3-6
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 3 Initial Configuration
ML-Series IOS CLI Console Port
Step 3 Insert the RJ-11 modular plug end of the supplied console cable adapter into the RJ-11 serial console
port, labeled CONSOLE, on the ML-Series card faceplate.
Figure 3-4 shows the ML1000-2 faceplate
with console port. For the ML100T-12 and ML100X-8, the console port is at the bottom of the card
faceplate.
Figure 3-4 Connecting to the Console Port
Step 4 Attach the supplied RJ-45-to-DB-9 female DTE adapter to the nine-pin DB-9 serial port on the PC.
Step 5 Insert the other end of the supplied cable in the attached adapter.
ML1000
2
FAIL
ACT
CONSOLE
ACT
LINK
TX
1
RX
ACT
LINK
TX
2
RX
78994
RJ-45 Cable
RJ-11 to RJ-45
Console Port Adapter Cable
ML1000-2 CONSOLE Port
for RJ-11 Module Plug