Cisco 15327 - Manual (Page 484)

A-10
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] pos scramble-spe
[no] pos scramble-spe
Use this command to enable scrambling.
Syntax Description This command has no arguments or keywords.
Defaults The default value depends on the encapsulation.
Command Modes Interface configuration mode (POS only)
Usage Guidelines This value is normally configured to match the setting on the peer PTE. This command might change the
pos flag c2 configuration.
Examples In this example, interface is shortened to int.
Gateway(config)# int pos0
Gateway(config-if)# pos scramble-spe
Related Commands None
Encapsulation Scrambling
LEX pos scramble-spe
PPP/HDLC no pos scramble-spe