Microcode fail system-reload – Cisco 15327 User Manual
Page 480
Advertising
A-6
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
microcode fail system-reload
microcode fail system-reload
In the event of a microcode failure, use this command to configure the ML-Series card to save
information to the flash memory and then reboot. The information is saved for use by the Cisco Technical
Assistance Center (Cisco TAC). To contact TAC, see the
Obtaining Technical Assistance, page xxxiv
.
Defaults
N/A
Command Modes
Global configuration
Usage Guidelines
This command and feature is specific to ML-Series card.
Examples
router(config)# microcode fail system-reload
Related Commands
N/A
Advertising