Cisco 15327 - Manual (Page 483)

A-9
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] pos trigger defects condition
[no] pos trigger defects condition
Use this command to specify which conditions cause the associated POS link state to change. Use the
no form of the command to disable triggering on a specific condition.
Syntax Description
Defaults The default is to report all conditions. For a list of all conditions, see the list in the Syntax Description.
Command Modes Interface configuration mode (POS only)
Usage Guidelines This value is normally configured to match the setting on the peer PTE.
Note In previous Cisco IOS releases, the pos trigger delay command was used to modify the triggering
interval. In Release 7.2, this command is not supported.
Examples In this example, interface is shortened to int.
Gateway(config)# int pos0
Gateway(config-if)# pos trigger defects all
Related Commands None
Parameter Description
condition The SONET/SDH condition that causes the link state change. The
conditions are as follows:
all—All link down alarm failures
ber_sd_b3—PBIP bit error rate (BER) in excess of SD threshold failure
ber_sf_b3—PBIP BER in excess of SF threshold failure
encap—Path Signal Label Encapsulation Mismatch failure
pais—Path Alarm Indication Signal failure
plop—Path Loss of Pointer failure
ppdi—Path Payload Defect Indication failure
pplm—Payload label mismatch path
prdi—Path Remote Defect Indication failure
ptim—Path Trace Indicator Mismatch failure
puneq—Path Label Equivalent to Zero failure