Cisco 15327 - Manual (Page 506)

A-32
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
show controller pos interface-number [detail]
show controller pos interface-number [detail]
Use this command to display the status of the POS controller. Use the detail argument to obtain
additional SONET and POS information for the interface.
Syntax Description
Defaults N/A
Command Modes Privileged executive
Usage Guidelines This command can be used to help diagnose and isolate POS or SONET problems.
Examples The following example is an example of POS continuous concatenation circuit (CCAT) show controller
output.
Router(config)# show controller pos 0
Router# show controller pos 0
Interface POS0
Hardware is Packet/Ethernet over Sonet
Concatenation: CCAT
Circuit state: IS
PATH
PAIS = 0 PLOP = 0 PRDI = 0 PTIM = 0
PPLM = 0 PUNEQ = 0 PPDI = 0 PTIU = 0
BER_SF_B3 = 0 BER_SD_B3 = 0 BIP(B3) = 20 REI = 2
NEWPTR = 0 PSE = 0 NSE = 0
Active Alarms : None
Demoted Alarms: None
Active Defects: None
Alarms reportable to CLI: PAIS PLOP PUNEQ PTIM PPLM PRDI PPDI BER_SF_B3 BER_SD_B3
VCAT_OOU_TPT LOM SQM
Link state change defects: PAIS PLOP PUNEQ PTIM PPLM PRDI PPDI BER_SF_B3
Link state change time : 200 (msec)
DOS FPGA channel number : 0
Starting STS (0 based) : 0
VT ID (if any) (0 based) : 255
Circuit size : VC4
RDI Mode : 1 bit
C2 (tx / rx) : 0x01 / 0x01
Framing : SDH
Path Trace
Mode : off
Transmit String :
Expected String :
Received String :
Buffer : Stable
Parameter Description
interface-number Number of the POS interface (0–1)