Cisco 15327 - Manual (Page 546)

A-72
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
show rpr-ieee topology detail
show rpr-ieee topology detail
Use this command to display topology information gathered by the station from the protection and ATD
messages received on either span of an IEEE 802.17b based RPR ring.
Syntax Description This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged executive
Usage Guidelines Use this command to obtain an extremely detailed status of the ring, including details about each
station’s configuration.
Examples router# show rpr-ieee topology detail
802.17 Topology Display
RX ringlet0->West spanRX ringlet1->East span
Number of nodes on
ringlet0: 5ringlet1: 5
=======================================================================
Local Station Topology Info
=======================================================================
Topology entry:
Station MAC address: 0005.9a3c.59c0
West Span (Outer ringlet RX) neighbor 000b.fcff.9d34
East Span (Inner ringlet RX) neighbor 0013.1991.1fc0
Ring Topology: CLOSED (STABLE)
Containment Active: NO
A0 class reserved rate:
ringlet0: 0 (mbps)ringlet1: 0 (mbps)
Ringlet reserved rate:
ringlet0: 0 (mbps)ringlet1: 0 (mbps)
Ringlet unreserved rate:
ringlet0: 96 (mbps)ringlet1: 96 (mbps)
Ringlet effective unreserved rate:
ringlet0: 95.9 (mbps)ringlet1: 95.9 (mbps)
Advertised Protection requests:
ringlet0: IDLEringlet1: IDLE
Active Edges:
ringlet0: NO ringlet1: NO
Configured protection mode: STEERING
Jumbo preference: NOT SET (ring doesn't support JUMBOS)
Is revertive: YES
Measured LRTT: 0
Sequence Number: 3
ATD INFO:
ATD timer: 1 sec
Station Name: ML100T-481
A0 reserved Bandwidth:
ringlet0: 0 mbpsringlet1: 0 mbps
SAS enabled: YES