Cisco 15327 - Manual (Page 76)

4-10
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 4 Configuring Interfaces
Configuring the POS Interfaces (ML100T-12, ML100X-8 and ML1000-2)
pkts_error_giants 0
pkts_good_runts 0
pkts_error_runts 0
pkts_ucast 0
pkts_mcast 5485
pkts_bcast 0
Rx Sync Loss 0
Overruns 0
FCS_errors 0
GMAC drop count 0
Symbol error 0
Rx Pause frames 0
MAC Transmit Counters
5d00h: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to down
5d00h: %ETHERCHAN-5-MEMREMOVED: GigabitEthernet0 taken out of port-channel1
5d00h: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed
staBytes 1952660
pkts64 0
pkts65to127 0
pkts128to255 0
pkts256to511 5485
pkts512to1023 0
pkts1024to1518 0
pkts1519to1530 0
Good Giants 0
Unicast packets 0
Multicast packets 5485
Broadcast packets 0
FCS errors 0
Tx Pause frames 0
Ucode drops 0
Example 4-6 show controller Command Output for RFI on Near-end Card with Near-end Fault
Near_End# show controller gigabit ethernet 0
IF Name: GigabitEthernet0
Port Status DOWN
Port rxLosState No signal
Remote Fault Indication 00 (no error)
Local Fault Indication 01 (link error)
Port 0 Gmac Loopback false
Example 4-7 show controller Command Output for RFI on Far-end Card with Near-end Fault
Far_End# show controller gigabit ethernet 0
IF Name: GigabitEthernet0
Port Status DOWN
Port rxLosState Signal present
Remote Fault Indication 01 (link error)
Local Fault Indication 00 (no error)
Port 0 Gmac Loopback false
Configuring the POS Interfaces (ML100T-12, ML100X-8 and ML1000-2)
Encapsulation changes on POS ports are allowed only when the interface is in a manual shutdown
(ADMIN_DOWN). For advanced POS interface configuration, see
Chapter 5, “Configuring POS.”