A&D Weighing Indicator AD-4329 - Manual (Page 53)

Set Zero band
Set the zero band value of the setpoint comparison. The decimal point is not
necessary because of according to display.
Templete
Command
Reply
S3, [value]
[s 3 A±mm_
Cpt|Lp|
fs IL ■fj 7\ 4j 8|%|^|
12.1,7. Related Functions
F-Function Description
Output Data
f~H0 0 Displayed data
F-HO 1 Gross data
F-HOS Net data
F~HÜ3 Tare value
F-% H Gross data / Net data / Tare value
Output mode F-Funciion Description
Stream mode F-HIÜ Description of “Stream Mode“ at page 31
Auto print mode F-% 1 Description of "Auto Print Mode" at page 31
Manual print mode F~^[j 3 When pressing the
print
key each time, the data is output once.
Command mode
(no address)
F-%3
Refer to "12.1.3.Command Format" of RS-232C interface.
Command mode
with address
Auto-print condition F-Function Description
Positive data only F-H3 0
"inhibition regiori of output" ^*f5d.
-1-5D < "permission region of output".
Positive and
negative data
F-% 1
-5d ^ "inhibition region of output" S -fSd.
"Permission region of output" < -5d, +5d < "permission region of output".
F"Function Description
Delay for continual
data F-%ü Not used
F-% 1 Approximately 2 seconds
Baud rate 600 bps, 1200 bps, 2400 bps, 4800 bps, 9600 bps
Data format F-HS Referto "12.1.2.Data Format" of RS-232C interface.
F-%
Address
BO to
33
Factory setting is BB,
When F - H 1 H is not selected, f-% is ineffective.
CF-Functlon Description
[F-Bl Data output of tare
[F-B8 Output on over load and unstable state. Use or not used
[F-B3 Format of Header Selection of TR, PT, GS, NT, T, G and N
l F- IB Figure number of unit, decimal point Two figures or three figures, dot or comma
[F- II Accumulation function Effective or ineffective
AD-4329 Weighing Indicator Page 49 12. RS-232C Interface