Denso BHT-7500 - Manual (Page 106)

86
[5.9] Testing with PING (BHT-7500S/7500W only)
TEST PING
1:RUN PING
2:SET PING
Selecting "9:PING" on the TEST menu calls up the
screen shown at left.
1 RUN PING : Runs PING.
2 SET PING : Switches to the PING parameter
setting screen.
Select a desired item by using the numerical keys
or
and keys, and then press the ENT key.
To return to the TEST menu, press the C key.
(1) PING screen
(No.-of-echo requests entry screen)
Selecting "1:RUN PING" on the TEST PING menu
calls up the screen shown at left where the current
settings are displayed.
The COUNT entry box enclosed with brackets is
ready to accept data. If you want to modify the
number of echo requests displayed, enter the de-
sired value by using the numerical keys.
To delete a single character, press the BS key ( SF
+ C keys). To delete the whole entry you made,
press the C key.
Press the ENT key to start PING.
RUN PING
DESTINATION IP
XXX.XXX.XXX.XXX
DATA SIZE XXXXX
INTERVAL XXXXX
TIMEOUT XXXXX
SEND TYPE TYPEn
COUNT [XXXXX ]
(PING running screen)
Once PING starts running, the message shown at
left will appear.
To stop PING, press the C key.
The PING result may include the following:
OK : Displays the number of echo replies.
[XXXXX]: Echo reply time in millisec-
onds
NG : Displays the number of errors found
during execution of PING.
TIMEOUT : Displays the number of timeouts (for
echo replies) that took place during
execution of PING.
⇑
RUN PING
DESTINATION IP
XXX.XXX.XXX.XXX
DATA SIZE XXXXX
INTERVAL XXXXX
TIMEOUT XXXXX
SEND TYPE TYPEn
COUNT [XXXXX ]
***** PING start *****
OK : XXXXX [XXXXX]
NG : XXXXX
TIMEOUT : XXXXX
***** PING end *****