Denso BHT-7500 - Manual (Page 123)

103
Chapter 2. Getting Started the BHT and System Mode
BHT-7500W
SET WEP KEY1
1:KEY SIZE
40 128
2:KEY
**********
SET WEP KEY1
1:KEY SIZE
40 128
2:KEY
ABCDE12345
Defining WEP KEY 1
Selecting the "1:WEP KEY1" on the WEP KEY defi-
nition screen displays the "** Now Loading **."
After that, the screen shown at left will appear.
The "1:KEY SIZE" shows the current setting. The
"2:KEY" shows asterisks (*) of the key size to ob-
serve secrecy.
Select a desired item by using the numerical keys
or
and keys.
To select the desired key size, use the Use the
and
keys.
To enter the desired WEP key, select the "2:KEY"
and then press the ENT key. The screen enters
the alphanumeric entry mode in which a cursor
appears.
You may overwrite the current key with the de-
sired key, but may not edit or delete it.
For details about the WEP key, refer to Subsection
3.1.2.
If no asterisk (*) appears for the "2:KEY," it
means that the BHT-7500W has no WEP key
preset. When no WEP key can be defined,
the "40" is highlighted for the "1:KEY SIZE."
Shown at left is an WEP definition screen being
halfway through entry. In this example, the WEP
key is defined as "ABCDE12345."
An WEP should be a 10- or 26-digit hexadecimal
(with 0 through 9 and A through F).
If the key size is 40 or 128, the WEP key should be
10 or 26 digits, respectively.
To switch the entry mode between the numeric
mode (without guidance) and alphabet mode, press
the SF key. After completion of settings, press the
ENT key.
In the entry mode, to delete a single character,
press the BS key ( SF + C keys). To delete the
whole entry you made, press the C key.