Denso BHT-7500 - Manual (Page 84)

64
(2) Communications protocol option screen
Selecting "2:PROTOCOL" on the SET CONNECTOR
screen calls up the screen shown at left.
Highlighted is the current setting.
1 SERIAL No.: Selects whether or not the
system will add serial num-
bers to data blocks.
2 H. PARITY: Selects whether or not the
system will add a horizontal
parity.
3 LINKUP TIME: Selects the timeout length (in
seconds) to be applied when
a link is to be established.
4 FIELD SPACE: Selects whether space codes
in the tail of a data field will
be ignored or handled as
data.
Select a desired item by using the numerical keys
or
and keys. Then select a desired setting
by using the and keys.
To return to the SET CONNECTOR screen, press
the C key.
If the BHT-Ir protocol has been selected, the
serial number and horizontal parity settings
will be ignored.
SET PROTOCOL
< CONNECTOR >
1:SERIAL No. : ON OFF
2:H.PARITY : ON OFF
3:LINKUP TIME:
None 30 60 90 120
4:FIELD SPACE:
Ignore Data