Denso BHT-7500 - Manual (Page 121)

101
Chapter 2. Getting Started the BHT and System Mode
BHT-7500W
SET RF OPTION
1:POWER SAVE
ON OFF
2:WEP
ON
OFF
3:AUTHENTICATE
OPEN SHAREDKEY
SET RF OPTION
1:POWER SAVE
ON OFF
2:WEP
ON
OFF
3:AUTHENTICATE
OPEN SHAREDKEY
Set up?
1:Yes
2:No
[8.1.2] RF option screen
Selecting the "2:RF OPTION" on the RF parameter
menu displays the "** Now Loading **." After
that, the screen shown at left will appear where
the current settings are displayed.
1 POWER SAVE Places the wireless module
in the energy saving mode.
2 WEP Enables or disables the WEP
(Wired Equivalent Privacy).
3 AUTHENTICATE Sets the authentication sys-
tem when the WEP is en-
abled.
Select a desired item by using the numerical keys
or
and keys. Then select a desired setting
by using the and keys.
For details about the RF parameters, refer to Sub-
section 3.1.2.
Pressing the ENT or C key will display the
confirmation message as shown at left.
To save the new entry, choose "1:Yes" and press
the ENT key. The "** Now Setting **" will appear
and the screen will return to the RF parameter
menu.
To cancel the new entry, choose "2:No" and press
the ENT key. The newly entered data will be
discarded and the screen will return to the RF
parameter menu.
When the "** Now Setting **" is displayed,
the new entry will be written onto the
EEPROM of the wireless module built in the
BHT-7500W.
While this message is displayed, do not turn
the BHT off. Writing halfway onto the
EEPROM will not bring any assured settings.