LINK Systems System 2500 PLS - Manual (Page 33)

System 2500 Operating & Installation Manual - Revision 07 2-25
Figure 4
Recalling a Setup
When the operator chooses RECALL from the Store/Recall Menu, the Recall Menu is displayed.
This menu gives the operator two options for choosing the setup name to be recalled. These are
listed on the display as follows:
C
ENTER SETUP NAME - The name of the setup to be recalled can be entered
directly using this option.
C
VIEW NAMES - The operator may view a listing of all the stored setups in
backup memory, and choose one to recall.
2.7.2.1 Recall Setup, ENTER SETUP NAME
If ENTER SETUP NAME is chosen the System 2500 will then prompt the operator to enter the
name of the setup desired. If the name contains alpha characters, the ALPHA key must be
pressed before each alpha character to be entered. Alpha characters are printed in the lower left
corner of their corresponding keys. When the ALPHA key is pressed, the line under the next
character for the setup name will be a double line rather than a single line. If a mistake is made
while entering the setup name, the left arrow key can be pressed to erase the last character
entered. To erase the entire name and start over from the beginning, the CLEAR key should be
pressed.