LINK Systems System 2500 PLS - Manual (Page 67)

System 2500 Operating & Installation Manual - Revision 07 4-9
Figure 27
Wiring of LINK 3040 Infrared Parts Detector
5. Run the machine in the proper direction. Verify that the angle is increasing as the
machine rotates. If the angle is decreasing, the resolver must be wired for the
opposite rotation.
6. Set the machine offset. This procedure is described in Section 2.5.6.
7. Set the machine Topstop angle. This procedure is described in Section 2.5.3. If
the machine is a variable speed machine, it may be desirable to set up the Topstop
angle to be speed advanced. Follow the procedure described in Section 2.5.4 for
programming Topstop Speed Advance.