LINK Systems System 2500 PLS - Manual (Page 71)

System 2500 Operating & Installation Manual - Revision 07 5-3
3) Verify that resolver cable is properly wired to 6-pin plug-in terminal strip for
Logic Unit.
4) Verify that 6-pin plug-in terminal strip is securely installed into header
(receptacle) on Logic Unit.
5) Notify factory.
061 SETUP IN BACKUP MEMORY HAS BAD DATA - SETUP NOT RECALLED
1) The setup that you attempted to recall contains invalid data. You may choose
to remove the setup from backup memory to eliminate it. You may also choose to
replace the bad setup in backup memory so that it can be recalled again in the
future. To do this, you must program the current setup so that it has the same PLS
setpoints and Die Protection information as the setup you wanted to recall (using a
written backup copy of that setup). Then you can store the new current setup in
backup memory using the same name. This will give you a new copy in backup
memory of the setup you tried to recall.
062 PLS SETUP DATA INVALID!
PLS SETUP WILL BE LOST! PRESS 6,2, & CLEAR.
The PLS data in the current setup has been found to be corrupt. When the error is
cleared there will be no PLS data in the current setup. This means that the output
channels will not be programmed to switch on and off, no output channels will be
restricted, no channels will be tied to the counter, etc.
To clear this error the operator must be in the STOPS/FAULTS menu and this
error message must be on the display. Also, the mode selector keyswitch must be
in the PROG position. The operator must then press the 6 key and the 2 key
before pressing CLEAR. After clearing this error, Error 66 will appear. The
operator then has these options:
1) Go to the Store/Recall menu and recall a setup which has the proper PLS
setpoints programmed for this die.
2) Manually enter new PLS information for the current setup.
063 CONFIGURATION DATA INVALID!
RE-ENTER CONFIGURATION AND COUNTER DATA!
1) The data stored for configuring the System 2500 to this machine has been