MOCET IG7600 - Manual (Page 18)

IG7600 Administration Manual
Since the priority is allowed, we should check the allowed table first.
In Allowed table, since 1000000 has 7 digits, you can only dial the number that is
between 1000000 and 2000000 with a length not less than 7, and the extension you
use must have a COS level higher or equal to “7”.
If you’ve passed the Allowed Table, check the Denied Table then, This Denied table
means that when you dial the number directly, and the first three number is
between 180 and 189, your extension must have a COS level higher or equal to “1”,
if not, your call will be rejected by IG.
3.12 Call Routing
The Call Routing feature automatically routes outgoing calls using the most appropriate
route. The appropriate route is determined based on the number dialed. If necessary,
IG7600 can automatically modify the dialed number by deleting and inserting digits.
The call routing destination is a PSTN line, an IP line or a line group. It allows you to
configure each entry in the Call Routing Table which contains a routing rule for outgoing
calls:
- From/To setting defines the number range
- Min/Max defines the match length
- Del can delete some leading digits in the dialed number.
- Insert can add some digits as the leading for the target number. It will be added
after doing “Del”.
- Destination defines the outbound call interface trunk
3.13 Caller ID Detection/Generation
IG7600 provides the ability to detect the calling party identification provided by CO via
PSTN lines or by Uplink Server via IP trunks. This data when received by the telephone
carrier will be displayed on all ringing IP phones.
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 12 of 127