MOCET IG7600 - Manual (Page 89)

IG7600 Administration Manual
6.6.2.5 Call Routing
This page allows you to configure the call routing table. A maximum 100 entries are
allowed. Each entry is a routing rule for outgoing call. From/To define the number range,
Min/Max define the match length, Del/Insert can change the target number, Destination
to define the outbound call interface. (Figure 6-57)
Figure 6-57. Voice – Trunk – Call Routing Table – 1
6.6.2.6 Call Restriction
This page allows you to configure the Call Restriction Table. A maximum 40 entries are
allowed.
There are two types of Call Restriction Table, Allowed Table and Denied Table (Figure
6-58):
Each entry has an interval, which is made up of From and To, establishing a numeric
range. For example, an entry of “From 1700”, “To 1800” includes the following range of
numbers as the leading: 1700, 1701, 1702 …1799, 1800. Each From/To entry can be
from 1 to 13 digits long and may contain any digit 0-9, *, #, X/x (representing any digit)
and +. The “From” entry must be less than or equal to the “To” entry.
If the Trunk Access value is set to “Y”, the entry is valid when the trunk is accessed
previously. If the field is set to “N”, the entry is valid when the trunk is NOT accessed
previously (The call may be made through Call Routing Table). If the option is set to “YN”,
the entry is valid no matter the trunk is accessed or not previously.
The COS value defines COS values that are considered to be matched for this entry. For
the Allowed Table, the entry is matched when the extension’s COS value is smaller than
or equal to it; while for the Denied Table, the entry is matched when the extension’s COS
value is larger than or equal to it.
Table Type decides into which table this entry will be added.
Priority decides which table will be checked first. If Priority is “Allowed”, IG7600 will check
Allowed Table first, if any entry is matched IG7600 will search Denied Table then, the call
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 83 of 127