MOCET IG7600 User Manual
Page 85
IG7600 Administration Manual
Subscriber Information:
Phone Number: It’s the assigned phone number from uplink server.
Auth ID: The Account ID of registration to uplink server. It’s used for Digest
Authentication.
Auth Password: The Password of registration to uplink server. It’s used for Digest
Authentication.
SIP Proxy: The position of uplink SIP proxy server. IP address and domain name are
all supported.
SIP Proxy Port: The SIP signal port of uplink registrar server.
Outbound Proxy: The address of uplink outbound proxy server. All sip request packet
will be sent to this server that will determine their next hops.
Outbound Proxy Port: The SIP signal port of uplink outbound proxy server.
Register Proxy: The position of uplink register server. IP address and domain name
are all supported.
Register Proxy Port: The SIP signal port of uplink registrar server.
Outbound Registrar: The address of uplink outbound Registrar server. All
REGISTER packets will be sent to this server that will determine their next hops.
Outbound Proxy Port: The SIP signal port of uplink outbound registrar server.
Register Expires: It’s the time for IG7600 sends REGISTER to uplink register server.
It counts based on second.
Outgoing Caller ID: It’s used as the Caller ID for the outgoing calls.
Registration: If “Registration” is No, the IP Trunk will not send REGISTER to the
Register Proxy.
Support E.164: If “Support E.164” is Yes, the IP Trunk follows E.164 format to send to
outgoing phone number.
Support DID: If “Support DID” is a digit, the IP Trunk is used in DID operation. The IP
Trunks from the current one to the specified IP Trunk are applied in the specified
account. For example, if the setting is “5” in IP Trunk 1, the account is applied for IP
Trunk 1 to 5. It means it can have 5 concurrent calls in the account.
Server Type: If “Server Type” is CHTM, and if the Caller ID of the incoming Trunk call
exists, IG7600 will use the Caller ID in From and P-Asserted-Identify header in the
outgoing IP Trunk call.
Local Port:
Local SIP Port for IP Trunk: SIP control signal packet Port of IP Trunk Client. The
port number cannot be the same as the “SIP Port” for Extension Registration.
Local RTP Port for IP Trunk: Real-Time Protocol packet Port of IP Trunk Client. It’s
the start RTP port address for these IP Trunks.
End Dial:
If “Support End Dial on #” is Yes, outgoing number from IP trunk will be sent out
immediately after pressing pound key (#).
Interdigit Timeout:
Copyright 2013 Tecom, Co. LTD. All rights reserved
Page 79 of 127