MOCET IG7600 - Manual (Page 87)

IG7600 Administration Manual
6.6.2.3 Trunk Group
This page allows you to configure the virtual Trunk Group. Up to 4 Trunk Groups are
supported. (Figure 6-54, Figure 6-55)
Trunk Group & Label Name:
This item allows you to assign physical Trunk to virtual Trunk Group. For four PSTN
lines and four IP lines you can choose from Group1 to Group 4.
PS: There is a special trunk group named Group ALL, all lines are considered
to be a member of the group.
Label Name:
This item allows you to configure a specified string as incoming Caller ID name. For
PSTN incoming call, it will be applied if no Caller ID received in the call. For IP Trunk
call, it will replace the original Caller ID name.
Ring Type:
The specific ring type assigned to the Trunk Line is the ring type heard when the Trunk
Line rings. The ring type is applied for IP2061/M22/M62 phone only.
Trunk Group Priority:
This Item allows you to define 4 Trunk Groups and Group All’s interior priority.
Access Priority:
This Item allows you to define 4 Trunk Groups and Group All's interior priority. For
the five groups you can choose IP first or PSTN first. This will take effect if call
routing entry’s destination has been set as Group choice.
Search Order:
You can choose the search order to use the specified access priority. For example,
when you choose IP First and increase, IG7600 will try to find an available IP Trunk
and search from the first IP Trunk in the Group.
Figure 6-54. Voice – Trunk – Trunk Group – 1
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 81 of 127