MOCET IG7600 - Manual (Page 72)

IG7600 Administration Manual
Control Sideband: Specify if the extension channel should be in the “Upper” or
“Lower” sideband.
802.11n Rate: Set the Physical Layer rate. These rates are only applicable when
the”802.11n/EWC” is configured as “Auto”.
802.11n Protection: In “Auto” mode, the wireless devices use RTS/CTS to improve
802.11n performance in mixed 802.11g/802.11b networks. Turn protection off to
maximize 802.11n throughput under most conditions. Do not disable 802.11n
protection if there is a possibility that 802.11b or 802.11g devices will use your wireless
network.
Support 802.11n Client Only: “On” enables support for 802.11n clients only. Off will
enable support for clients that are not 802.11n.
54g® Rate: The default setting is Auto. The range is from 1 to 54Mbps. The rate of
data transmission should be set depending on the speed of your wireless network.
You can select from one transmission speed, or keep the default setting, Auto, to have
the IAD automatically use the fastest possible data rate.
Multicast Rate: The default setting is 54Mbps. The range is from 1 to 54Mbps. The
rate of data transmission should be set depending on the speed of your wireless
network. You can select from one transmission speed, or keep the default setting, to
have the IAD automatically use the fastest data rate for multicast packets.
Basic Rate: Select the basic rate that wireless clients must support.
Fragmentation Threshold: This value should remain at its default setting of 2346.
The range is 256~2346 bytes. It specifies the maximum size for a packet before data
is fragmented into multiple packets. If you experience a high packet error rate, you
may slightly increase the Fragmentation Threshold. Setting this value too low may
result in poor network performance. Only minor modifications of this value are
recommended.
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 66 of 127