MOCET IG7600 - Manual (Page 51)

IG7600 Administration Manual
6.4 Advanced Setup
Advanced Setup allows system administrator to configure the following topics:
 WAN
 LAN
 NAT
- Virtual Servers
- Port Triggering
- DMZ Host
 Security
- IP Filtering
 Outgoing
 Incoming
 Parental Control
- Time Restriction
- URL Filter
 Quality of Service
- DSCP Marking
- Bandwidth Control
 Routing
- Static Route
 Dynamic DNS
 Upnp
6.4.1 WAN
There are three modes that you can give WAN IP address to IG7600: Static IP mode,
DHCP mode and PPPoE mode. You can also enable or disable Firewall.
Network Address Translation (NAT) allows you to share one public WAN IP address for
multiple computers on your LAN side. In IG7600, NAT is enabled by default and is not
shown on the page to prevent it from being disabled.
This page shows the setting of WAN interface which is Static IP mode (Figure 6-8).
Figure 6-8. Advanced – WAN (Static IP Mode)
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 45 of 127