Pitney Bowes DI600 Inserting System - Manual (Page 100)

6 • Troubleshooting
6-12 SV40221 Rev. C
Access to Areas 7 and 8
Areas 7 and 8 are located at
the inner ends of the Insert
Feeders F and G. Therefore,
before access can be gained
to a material stall in these
areas, the Insert Trays must
be removed as described on
page 6-9.
Once the trays are removed,
access to stalled material can
be gained by unlatching the
access covers shown.
Access to Area 6
Area 6 is located under Sheet
Feeder D, where envelopes
are fed into the system.
Therefore, before access can
be gained to a material stall
in this area, Sheet Feeder
Tray D should be removed as
described on page 6-9.
Once the tray is removed, access to stalled material can be gained
by unlatching the lever shown in the illustration above.
Area 7
Area 8