Pitney Bowes DI600 Inserting System - Manual (Page 103)

Troubleshooting • 6
6-15 SV40221 Rev. C
Envelope Stop Position
This function lets you adjust the position where the Outer Envelope
is held, waiting for material to be placed into it. It is accessed by
running a Trial Piece and replying ‘No’ when asked if the Trial Piece
is OK.
This adjustment will
only be needed in unusual situations where
material is not being placed fully into the envelope, or is being driven
too far, causing damage to the envelope or material.
The Envelope Stop has five positions...
0 Standard setting for normal weight material.
-1, -2 Places the material further into the mailing envelope,
which may be useful for light or thin material.
+1, +2 Reduces how far the material goes into the
envelope, which may be useful for thicker or heavier
material.
After carrying out this adjustment, you will be offered two options:
1. You can save the adjustment as part of the current Job Definition
so that it is automatically recalled in future. This requires
a Supervisor Access Code to be entered because the Job
Definition is being edited.
2. You can run the current job with the adjustment applied
temporarily. Once a new Job Definition is selected, or if power is
turned off, this temporary adjustment will be lost.
When the Envelope Stop
is set to any poston other
than ts standard (0) poston,
a warning icon showing
the modified setting will be
displayed beneath the Machine
Graphic.
Envelope Stop Icon