Pitney Bowes DI600 Inserting System - Manual (Page 36)

3 • Operator Functions
3-6 SV40221 Rev. C
If the Trial Piece is NOT OK, select No and follow the on-screen
instructions to correct the error. You can adjust the address position,
fold panel length and/or the envelope stop position. The envelope
stop position will rarely need adjusting - for more information, see
page 6-15.
Once the adjustment is made and any further Trial Piece is OK, you
will be asked if you wish to save the changed settings as part of the
Job Definition.
If you choose
Yes...
The machine will save the changed setting(s) as part of the
current job. Next time the original Job Definition is selected,
the modified adjustment(s) will be remembered.
A Supervisor Access Code (see page 4-2) will be requested,
as you are editing an existing Job Definition.
If you choose No...
The adjustment(s) you have just changed will only be
retained while you are running the current job. If another Job
Definition is selected or if power is turned off, next time the
original Job Definition is selected, the modified adjustment(s)
will have returned to the value saved within the Job
Definition.
TIPS:
If you reload material during a run which seems to have
different characteristics (weight, color shade, etc.), or if
you have any problems with double detect, run another
Trial Piece. This allows the machine to recalibrate the
double detect function for the new material in case the
batches vary slightly.
After running a Trial Piece, the options
Fill Now, Fill
Later and Exclude will be displayed if a feeder which
is used within the job definition is not loaded. You can
either select ‘Fill Now’ and load the relevant feeder
immediately, select ‘Fill Later’ which lets you begin
running the selected job without immediately loading the
relevant feeder, or ‘Exclude’ to exclude the feeder from
the current run.