Pitney Bowes DI600 Inserting System - Manual (Page 38)

3 • Operator Functions
3-8 SV40221 Rev. C
SwiftStart™
SwiftStart™ allows you to load material into the feeders and run a
simple job with minimal setup information.
The job can then either be run without saving it to the machine’s
memory, or a Supervisor can name and save the Job Definition for
future recall as and when required.
TIP:
SwiftStart™ can be used as a way to quickly
programme a new Job Definition. Load material and run
SwiftStart™. A Supervisor can save the new job and
then use the Edit Job function (see page 4-4) to make
minor changes, if necessary.
Constraints and Requirements
• Only use closed flap envelopes.
• Feeds only single sheets from each Sheet Feeder.
• This mode cannot be used to run fold only or inserts only.
• You cannot link Sheet Feeders in this mode.
• The Envelope Sealer is always on (except for the Trial
Piece).
• The Batch Count is always off.
• The Sheet Length must be 11-1/2” (292mm).
• This mode will not work with OMR.
Loading Material for SwiftStart™
Loading Sheet Feeders
Depending on your envelope depth, the machine will automatically
select the fold type – Single or C (standard) fold.
For example, a standard sheet (8-1/2” x11”) inserted into a #10
envelope will receive a C fold, whereas a standard sheet inserted
into a 6” x 9” envelope will only receive a Single fold.