Pitney Bowes DI600 Inserting System - Manual (Page 17)

Introduction • 1
1-9 SV40221 Rev. C
Home
Press this key to take you back to the Home Screen. The Home
Screen is where you can run jobs and is the starting point for
accessing the menus.
Start
Starts automatic operation.
Trial Piece
Press this key to run test piece(s) so that you can check the machine
setup. Trial Piece(s) must be run before automatic operation can
begin using the Start key. If double detection is in use, the machine
calibrates itself automatically as it runs the Trial Piece(s). If the job
includes an Outer Envelope, it will be unsealed so that the contents
can be easily checked.
Clear Deck
Press this key to drive the material through and out of the system. It
can be used to clear the machine ready for automatic operation after
a stoppage has occurred, etc.
Stop
Stops automatic operation at the end of the next cycle.
Navigation Keys (▲▼◄► OK)
These keys are used to move a highlighted area around the display.
Once the desired area is highlighted, press the OK key to select it.
The ▲ and ▼ navigation keys can also be used to change values of
machine settings.
Screen Keys
These are the six round keys located directly to the right of the
display. These keys correspond to the changeable options on the
display alongside them and therefore are not labelled.