Pitney Bowes DI600 Inserting System - Manual (Page 95)

Troubleshooting • 6
6-7 SV40221 Rev. C
Problem Remedy Page
DOUBLE DETECT
The machine keeps turning Double Detect OFF
Double Detect
cannot calibrate
itself properly.
Double Detection might not be
possible with certain very thick
or heavily printed material. Either
change material or choose to run
with Double Detect OFF.
Machine stops for ‘doubles’ that aren’t there or feeds ‘doubles’
without stopping
Double Detect is
not turned ON.
Check Double Detect status.
Double Detect icon will appear
alongside all items where Double
Detect is operational.
Correct loading or have Supervisor
correct Job Definition as necessary.
1-11,
1-12
4-4
Double Detect
is not correctly
calibrated.
Run a Trial Piece whenever a
new batch of material is loaded to
recalibrate Double Detect. The new
batch might be of slightly different
thickness.
3-6