Altera MAX 10 Embedded Memory - Manual (Page 34)

Signal Required Description
clock
Yes The following list describes which of your memory clock must
be connected to the
clock
port, and port synchronization in
different clock modes:
• Single clock—Connect your single source clock to
clock
port. All registered ports are synchronized by the same
source clock.
• Read/Write—Connect your write clock to
clock
port. All
registered ports related to write operation, such as
data_a
port,
address_a
port,
wren_a
port, and
byteena_a
port are
synchronized by the write clock.
• Input/Output—Connect your input clock to
clock
port. All
registered input ports are synchronized by the input clock.
• Independent clock—Connect your port A clock to
clock
port. All registered input and output ports of port A are
synchronized by the port A clock.
inclock
Yes The following list describes which of your memory clock must
be connected to the
inclock
port, and port synchronization in
different clock modes:
• Single clock—Connect your single source clock to
inclock
port and
outclock
port. All registered ports are synchron‐
ized by the same source clock.
• Read/Write—Connect your write clock to
inclock
port. All
registered ports related to write operation, such as
data
port,
wraddress
port,
wren
port, and
byteena
port are
synchronized by the write clock.
• Input/Output—Connect your input clock to
inclock
port.
All registered input ports are synchronized by the input
clock.
outclock
Yes The following list describes which of your memory clock must
be connected to the
outclock
port, and port synchronization in
different clock modes:
• Single clock—Connect your single source clock to
inclock
port and
outclock
port. All registered ports are synchron‐
ized by the same source clock.
• Read/Write—Connect your read clock to
outclock
port. All
registered ports related to read operation, such as
rdaddress
port,
rdren
port, and
q
port are synchronized by
the read clock.
• Input/Output—Connect your output clock to
outclock
port. The registered
q
port is synchronized by the output
clock.
rden
Optional Read enable input for
rdaddress
port. The
rden
port is
supported when the
use_eab
parameter is set to
OFF
.
Instantiate the IP core if you want to use read enable feature
with other memory blocks.
5-6 RAM: 2-Ports IP Core Signals (Simple Dual-Port RAM) For MAX 10 Devices
UG-M10MEMORY
2015.05.04
Altera Corporation RAM: 2-PORT IP Core References
Send Feedback