Installing the quartus ii software – Altera Cyclone II FPGA Starter User Manual
Page 13
Altera Corporation
1–5
October 2006
Cyclone II FPGA Starter Development Kit User Guide
Getting Started
lists the file directory names and a description of their contents.
Installing the Quartus II Software
Install the Quartus II Web Edition Software Suite found in the Altera Design
Software Suite by performing the following steps:
1.
Insert the Quartus II Web Edition Software Suite CD-ROM into the
CD-ROM drive.
1
The CD-ROM should start an auto-install process. If it does not,
browse to the CD-ROM drive and double-click on the setup.exe
file.
2.
Follow the online instructions to complete the installation process.
1
If you have difficulty installing the Quartus II software, refer to
Installing the Quartus II Software in the Quartus II Installation &
Licensing Manual for PCs found at
www.altera.com
.
The Quartus II software is the primary FPGA development tool used to
create the reference designs used in this development kit.
Additionally, you may want to install the Nios II Embedded Design Suite
package also found in the Altera Design Software Suite. The Nios II
soft-core embedded processor runs on Altera FPGAs. Many of the
reference designs included in this development kit use the Nios
processor.
Table 1–1. Installed Directory Contents
Directory Name
Description of Contents
BoardDesignFiles
Contains the board design files. Use these files
as a starting point for a new prototype board
design.
Docs
Contains the development kit documentation
Examples
Contains the sample design files for the Cyclone
II FPGA Starter Development Kit