Sdram/sram controller and programmer, Read/write data, Sdram/sram controller and programmer –4 – Altera Cyclone II FPGA Starter User Manual
Page 26
4–4
Altera Corporation
Cyclone II FPGA Starter Development Kit User Guide
October 2006
SDRAM/SRAM Controller and Programmer
2.
Click in the blank area under "PS/2 Keyboard" in the CII Starter Kit
Control Panel.
3.
Start typing on the PS/2 keyboard.
The keystrokes should echo from the keyboard to the output on the
control panel.
SDRAM/SRAM
Controller and
Programmer
The user can perform the following types of memory read/write
operations with the Control Panel:
■
Read/write data from/to the SDRAM or SRAM on the development
board
■
Write sequential data or the entire contents of a file, to the SDRAM or
SRAM
■
Read sequential data or the entire contents of the SDRAM or SRAM
to a file
This following sections describe how to access the SDRAM; the same
approach also applies to accessing the SRAM.
Read/Write Data
To write/read data from/to the SDRAM, perform the following steps:
1.
Select the SDRAM tab on the Control Panel (
).