Proceed CDP User Manual
Page 21
21
This turn-on output uses a two conductor
1
⁄
8
" mini-jack, as does the match-
ing input on the power amp. They may be connected using any standard
wire fitting those requirements. (Very little current is used, so there is no
practical gauge requirement on the wire.)
7
AC POWER INPUT
This input accepts AC power from the AC mains (via the supplied AC
cable).
Warning!
The CDP is set internally for 100, 120, 200, 220, or 240VAC mains
operation at either 50 or 60Hz. Make sure that the label on the
rear of the unit indicates the correct AC operating voltage
and frequency for your location before connecting it to AC
mains.
Connect the female end of this cable to the CDP. Connect the male end of
this cable to wall outlet or to an “unswitched” convenience outlet like those
found on some audio components.
AC power cord polarity
To CDP
To AC mains
1
3
2
1
2
3
1 = Line (hot)
2 = Neutral
3 = Earth ground
The power consumption of the CDP is only about 25 watts. As such most
people will leave it on (or in standby) at all times. If you elect to place the
CDP on a switched outlet, we advise waiting at least five seconds between
power cycles to allow the normal power-up sequence to complete without
interruption.