Proceed CDP User Manual
Page 31
31
remaining in the playlist. This next track will be shown with the
green
program LED
lit to indicate that it is still in the playlist.
4. Using
next
and
previous
, move to any other tracks you would pre-
fer to skip, pressing
program –
to eliminate each track from the
playlist. Once you are in the program mode, the green
program LED
will illuminate to indicate a track is in the playlist,
and extinguish for any track omitted from the playlist.
Reviewing a Playlist
To review your playlist before playing it:
1. Assemble a playlist and press
stop
.
2. Without selecting any particular track (while the playlist’s total num-
ber of tracks and total playing time are displayed), press
program +
.
The display will show the first selection in your playlist.
3. To view the next selection, press
program +
again, and so on.
4. After you view the last selection, one more press of
program +
will
cause the display to “wrap around” to the first track in the playlist.
(Alternatively, you may use the next and prev buttons to step through all the
tracks, noting which tracks are included in the program by watching for the green
program LED.)
Deleting a Track
from a Playlist
You may delete any selection from a playlist. To delete a selection:
1. Press
stop
after assembling a program.
2. Press
next
or
previous
until the selection you want to delete ap-
pears on the display (programmed tracks cause the program LED
to light green; non-programmed tracks extinguish it).
3. Press
program –
; the display will turn off the green
program LED
to indicate that the current track has been removed from the play-
list.
4. Repeat steps 3 and 4 for each selection you want to remove from
your program.
Adding a Track
to a Playlist
You also may add a selection to the end of a previously assembled playlist.
1. From stop, using the
next
and
previous
(or the numbered buttons
on the Remote Control), select the track you want to add to your
playlist.
2. Add the selection to your playlist by pressing
program +
.
3. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press
program +
after each selection.
Temporarily Ignoring
a Program
If you have created a program for the current disc but would like to temporarily
override it and listen to the entire disc, press
program –
from
stop
. The
program
LED
will extinguish to indicate the program has been overridden. Pressing
pro-
gram+
will restore the program.
Erasing a Program
If you have created a program for the current disc but would like to erase it from
memory, press and hold
program –
until
EP
(Erased Program) appears in the dis-
play, and the
program LED
is extinguished.