Proceed CDP - Manual (Page 27)

27
Basic Operation
Before operating your CDP, take a minute to become familiar with its controls
and their locations. (See “Front Panel” and “Remote Control.”)
Loading a CD To load a CD:
1. Enable the CDP’s controls by pressing standby if in standby.
2. Press stop/drawer to open the drawer.
3. Place a CD into the recess of the drawer, label side up. Handle the
CD by the outer edges and center hole only.
4. Press stop/drawer .
Playing a CD To play all tracks on the CD, press the play/pause button. All tracks will play in
order. Play will stop automatically at the end of the CD.
To begin play with a track other than the first track:
1. Before pressing play/pause , press next until the number of the
desired track shows on the Display. If you pass the track you want
to play, you can “back up” by pressing
prev . (You may also select
the track directly using the numbered buttons on the Remote Con-
trol.)
2. Press play/pause to begin playing that track. The remaining tracks
will play in order. Play will stop automatically at the end of the CD.
Pause To suspend play while a CD is playing, press play/pause . To resume play at the
same point, press play/pause again.
If left in pause for about two minutes, the transport will stop spinning automati-
cally and the laser will turn off (thereby enhancing the longevity of both). Press-
ing
play/pause again will resume play at the point where play/pause was first
pressed, after a short delay to find the correct starting point.
Random Play Using the Remote Control, you may have the CDP play tracks totally at random.
To do this, press the
rndm key, then press play . The random LED will illuminate
to indicate the random play mode. To cancel random play , press rndm a second
time, or stop .
Navigating the Disc You may skip to another track any time while a CD is playing. To move to an-
other track, press
next (to go forward) or prev (to go backward) until the number
of the track you want to play shows on the Display. (You may also select the track
using the numbered buttons on the Remote Control.) Play will resume as soon as
the pickup reaches that track.
You may search for a particular passage on the CD using fast forward and
rewind, by pressing and holding the next and prev buttons (respectively). Use the
reduced-volume audible scan available during these modes to search the CD un-
til the laser pickup reaches the passage you want to hear.