Proceed CDP - Manual (Page 6)

6
Unpacking and Placement
Unpacking the CDP Unpack your CDP Compact Disc Processor and remove all accessories from the
carton.
Important! Keep all packing materials for future transport of your CDP.
Shipping your new component in anything other than its
purpose-designed packing material may result in damage
that is not covered by the warranty.
Remove the Transport Screw Place the CDP Compact Disc Processor upside-down on a soft, clean surface. Re-
move the transport screw from the bottom of the unit and save it with the pack-
ing materials for future use.
Warning! The transport screw must be removed before operating the
CDP, since it immobilizes the transport mechanism during
shipping to prevent damage. This screw must also be
replaced before shipping the unit.
Placement of the CDP The CDP should be placed close to your preamplifier, thus keeping interconnect
cabling reasonably short. It may be placed on a shelf or in a cabinet where it is
convenient to operate.
Drawings are included in this manual to facilitate special installations and custom
cabinetry (see Dimensions).